PPS-08

The PPS-08 will drive EIGHT pedals from the same source, it’s more than a power supply, it’s a power conditioner which supplies a predictable voltage all the time and keeps your pedals in constant performance from one show to another.

Features

  • 8 outputs, with fully isolated ground.
  • 6-9v outlets and two ADJUSTABLE 9 volts, 12 volts and 18 volts.
  • Includes 8 DC cables to connect your pedals to the PPS-08, and one Y cable to boost the voltage.
  • Short Circuit Protection.
  • LEDs at each outlet light to indicate the mode as well as any faults in pedals. (When the LEDs are RED), the PPS-08 will enter a self-protection mode and will auto-restart in about 2 seconds after disconnecting the problem pedal.
  • FCLC (Foldback Current Limiting Circuit) provides protection against power shortages and overloads. Even at full load it is a fully regulated power supply.

Most battery-powered effects rarely exceed 30 milliamps each, you’re not likely to use anywhere near the PPS-08’s 2000 milliamp output.

Connections

  1. Plug the included AC adapter into the PPS-08’s POWER IN 12v/ 2000mA input jack.
  2. Connect the AC adapter to 100-240v AC power, the blue LED will light. *(If you use other AC adapters, be sure the output is 12v DC rated at 2000mA and the plug is positive barrel and negative center type.)
  3. Connect your 9v pedals to the SIX 9v outputs with included DC cables.
  4. Connect your 9v 12v or18v pedals to the A or B outputs with included DC cables. (Select voltage for these outputs using the switches located on the side of the unit.)
  5. Use the Y cable to connect from any of the 8 outlets to get the right voltage for any pedal that requires between 18v and 36v.

Technical Info

  • AC to DC adapter
  • INPUT: AC 100v-240v at 50/60Hz.
  • OUTPUT: DC 12v, 2000mA.
  • POLARITY: Positive Barrel and Negative Center.
  • DC Power Supply
  • OUTPUTS: 9v@300mA (x6), 9v/12v/18v@500mA (x2)
  • INPUT: DC 12v 2000mA
  • LEDs: Blue LED for power light, Green to go and Red to stop

Important Notice

  1. Use only 12v/2000mA output DC adapter with Positive barrel, Negative center polarity plug. Do not use any other adapters with different specifications.
  2. Unplug your PPS-08 when not in use for extended periods of time.
  3. Guard against water or other liquids entering the enclosure.

Package Contents

  1. PPS-08 Power Supply
  2. AC to DC adapter
  3. 8pcs DC cables and 1 ‘Y’ cable
  4. User Manual